Lawn mower won't start: step-by-step checks for petrol and battery mowers
The short answer
A small four-stroke mower engine needs three things to start: fresh fuel reaching the cylinder, a spark at the right moment, and air. When a mower that ran fine in autumn refuses to start in spring, one of those three is missing, and it is fuel far more often than the other two combined.
Petrol does not keep. Left in a vented mower tank for a few months it loses the light fractions that make it ignite easily and leaves a varnish that gums up the tiny passages in the carburettor. The engine may cough, run for a few seconds and die, or do nothing at all.
The steps below cover the common push and self-propelled four-stroke mowers sold in Australia, with a short section for battery mowers at the end. They go from free checks to a new spark plug and stop before the carburettor comes apart.
Likely causes, most common first
Stale fuel
DIYMower has sat for three months or more with petrol in the tank. Fuel smells sour or like varnish rather than sharp, and may look darker than fresh petrol.
Fouled or worn spark plug
DIYEngine turns over freely but never fires, or fires weakly. Plug tip is black and sooty, oily, wet with fuel, or the electrode is rounded and worn.
Safety bail not held or its cable stretched
DIY or professionalNo sign of life however many times you pull. The bar on the handle feels slack, or the cable is frayed, kinked or has come off at one end.
Clogged air filter or flooded engine
DIYStrong smell of petrol, a wet spark plug, black smoke if it does fire. Filter is caked with dust and grass or soaked in oil after the mower was tipped the wrong way.
Oil level wrong
DIYDipstick shows low or no oil, or the oil is well over the full mark. Overfilling causes heavy white smoke and hard starting.
Blocked carburettor
ProfessionalFresh fuel, a good plug and a clean filter, yet the engine only runs for a second or two on the primer, or surges and dies. Classic result of fuel left in over winter.
Before you start
Safety first
- Pull the spark plug lead off the plug and tuck it well clear before you tip the mower, reach under the deck or touch the blade. Turning the blade by hand can turn the engine over, and an engine can fire with the lead attached.
- Tip the mower with the air filter and carburettor side facing up, so the spark plug points to the sky. Tipping it the other way runs oil into the air filter and fuel out of the tank.
- Handle petrol outdoors, with the engine cold, away from pilot lights, barbecues, cigarettes and anything that sparks. Use a container made for fuel and wipe up spills.
- Do not pour old petrol on the ground, down a drain or into a bin. Take it in a sealed fuel container to a council transfer station or household chemical collection that accepts it.
- Wear sturdy gloves near the blade and enclosed shoes whenever you pull the starter cord.
- On a battery mower, remove the safety key and the battery before touching the blade or turning the mower over.
What you will need
- Fresh regular unleaded petrol in a clean fuel container
- Hand siphon pump and a sealable fuel container for the old petrol
- Spark plug spanner or a plug socket to suit your engine
- New spark plug of the type listed in the manual
- Engine oil of the grade in the manual, and a funnel
- Clean rags and sturdy gloves
- Replacement air filter if yours is past cleaning
Step-by-step checks
Step 1: Check the basics at the handle and tank
Start with the things that are easy to overlook. Is there fuel in the tank? If your mower has a fuel tap, usually a small lever near the tank or carburettor, is it on? Is the throttle or choke lever set to the start position?
Hold the safety bail, the bar you squeeze against the handle, fully closed while you pull the cord. Releasing that bar is how the engine is stopped, so if it is not fully held, or its cable has stretched, the engine has no ignition. Watch the cable at the engine end while someone squeezes the bar. It should move a lever through its full travel.
If your mower has a primer bulb, press it the number of times shown on the mower or in the manual, typically about three. You should feel resistance and see or hear fuel moving. A cracked primer bulb that will not spring back needs replacing.
Tip: If the starter cord will not pull, or is very hard to pull, disconnect the spark plug lead and check under the deck for a wad of dried grass or a stick jamming the blade.
Step 2: Replace stale fuel
If the petrol has been in the tank since last season, do not try to rescue it. Working outdoors with a cold engine, use a hand siphon pump to transfer the old fuel into a sealable fuel container. Do not start a siphon by mouth, and avoid tipping the mower over to pour fuel out.
Refill with fresh regular unleaded from the servo. Check your manual on ethanol blends: many small engine makers accept E10 but advise against leaving it in the tank for long periods. Prime the engine and try starting again. It can take several more pulls than usual for fresh fuel to reach the carburettor.
Take the old petrol to a council transfer station or a household chemical collection. Ring ahead or check your council's website, because not every site accepts fuel.
Careful: Fuel left in the fuel can since last year is just as stale as fuel left in the mower. Buy fresh.
Step 3: Check and replace the spark plug
Pull the rubber boot straight off the plug. Brush away grass and dirt from around the plug so nothing falls into the cylinder, then unscrew it anticlockwise with a plug spanner.
A healthy plug has a light brown or grey tip. Black and sooty means it has been running rich, often from a dirty air filter. Wet with fuel means the engine is flooded. Oily points to the mower having been tipped the wrong way or to engine wear. A rounded, eroded electrode is simply worn out.
A new plug costs less than $15, so if there is any doubt, replace it with the type specified in the manual rather than cleaning the old one. Thread the new plug in by hand first so it cannot cross-thread in the soft alloy head, then tighten it snugly with the spanner without leaning on it. Push the lead back on until it clicks.
Step 4: Clean or replace the air filter
The air filter sits under a plastic cover on the side of the engine, held by a clip, a knob or a single screw. A pleated paper filter can be tapped gently on a hard surface to shake out loose dust. If it is still grey and clogged, or has oil on it, replace it. Do not wash a paper filter or blow it out with high-pressure air.
A foam filter can be washed in warm water with dish detergent, rinsed and squeezed dry in a clean rag. Some engines call for a foam filter to be lightly oiled before refitting, so check the manual.
Do not run the engine without the filter. Dust drawn straight into the engine wears it out quickly.
Step 5: Check the oil level
With the mower on level ground, unscrew the dipstick, wipe it, refit it as the manual directs and read the level. Top up to the full mark with the grade specified, a little at a time. Small engines hold very little oil and it is easy to overfill.
Some engines have a low-oil cut-out that prevents starting. Even where there is none, running low on oil will destroy the engine. If the oil is black and gritty, or milky, it is due for a change.
Step 6: Clear a flooded engine
If you can smell petrol strongly and the plug came out wet, the engine has more fuel than it can ignite. This is common after repeated priming and pulling.
Leave the plug out and the mower standing level for 15 to 20 minutes so the fuel can evaporate. Dry the plug or fit the new one, then start without priming and with the choke off. Once it fires and clears its throat, it should settle.
Step 7: Battery mowers: battery, key and handle
A battery mower that will not start is usually an interlock doing its job. Check that the safety key is pushed fully in, the battery is clicked home until its latch engages, and the handle is fully unfolded and locked. Many models have a switch in the handle joint and will not run if it is not properly extended.
Press the charge indicator on the battery. If it is flat, put it on the charger and read the charger's lights against the label or manual. A battery that is hot from use or from a hot shed will often refuse to charge until it cools. If the mower cuts out in long or wet grass, raise the cutting height and let it rest, because the overload protection has tripped.
Careful: Stop using and charging any battery that is swollen, leaking, dented, overheating, smells or hisses. Use only the charger made for that battery system.
When to stop and call a repairer
- The engine has fresh fuel, a new plug and a clean air filter but still will not start, or only runs for a second or two after priming. The carburettor needs cleaning or rebuilding.
- The starter cord is jammed, will not recoil, or pulls with no resistance at all.
- Fuel is leaking from the carburettor, fuel line or tank.
- The mower hit something solid and now will not start, vibrates badly, or the blade is bent. A sheared flywheel key or bent crankshaft is possible.
- The safety bail cable is broken or the engine brake does not stop the blade within a few seconds of releasing the bar.
- A battery mower will not run with a charged, known good battery and the key and handle correctly set.
Stop using any battery pack that is swollen, cracked, leaking or getting hot. Charge on a hard surface with the supplied charger, not overnight or unattended, and take old packs to a B-cycle drop-off point. They must never go in household bins.
What it costs
- Doing it yourself
- Typically $5–$40: a few litres of fresh petrol, a spark plug at under $15, and an air filter that is commonly $10–$30.
- Professional repair
- A basic service on a four-stroke push mower is roughly $50–$100. Ride-on mowers are more, roughly $250–$400.
Indicative figures from limited Australian cost guides. Carburettor work, blades and other parts are extra, so ask for a quote before the work goes ahead. See our Melbourne repair cost guide for more.
Repair or replace?
A mower that will not start because of fuel, a plug or a filter is not worn out. Even a carburettor clean as part of a service is modest money against the price of a new mower, and a well-made engine will run for many more years afterwards.
Replacement becomes reasonable when the deck is rusted through, the engine is burning oil and low on compression, or the crankshaft is bent after a strike. Those repairs can exceed the value of a basic push mower.
To avoid the same problem next spring, run the tank nearly dry or add a fuel stabiliser before the mower is put away for winter, and start the season with fresh petrol. If you are replacing a battery mower, the old mower and battery are e-waste in Victoria and cannot go to landfill.
Not sure which way to go? Try the repair or replace calculator, and read your consumer rights before paying for a repair on something that failed early.
Common questions
How long does petrol last in a mower?
Petrol in a vented mower tank starts to deteriorate within a month or two and is often poor enough to cause starting trouble after three months or so. Fuel in a sealed, full container kept cool lasts longer. If it has been sitting since last season, replace it.
Which way do I tip a lawn mower?
Disconnect the spark plug lead first, then tip it so the air filter and carburettor are on the high side and the spark plug points upward. For most mowers, tilting it back onto its handle is the safest option of all. Check the manual if you are unsure which side the filter is on.
My mower starts, runs for a few seconds and dies. What does that mean?
It is running on the fuel from the primer and then starving. That pattern points to stale fuel or a blocked carburettor jet. Replace the fuel first. If it still does it, the carburettor needs a workshop clean. Also check that the fuel cap vent is not blocked by loosening the cap slightly and trying again.
Where can I get rid of old petrol in Melbourne?
Council transfer stations and household chemical collection days are the usual options. What each site accepts varies, so check with your council before you go, and transport the fuel in a sealed container made for the purpose. Never put it in a bin or down a drain.
White smoke is pouring out after I tipped the mower. Have I ruined it?
Probably not. Oil has run into the cylinder or the air filter. Check the oil level, replace the air filter if it is soaked, clean or replace the spark plug and run the engine outdoors. The smoke should clear within several minutes.
Melbourne repairers for lawn mowers & power tools
Independent businesses that list this kind of work. Listings are free and are not endorsements. Always confirm prices, licences and availability directly.
Mowers and More
Shopfront5/23 Cooper St, Campbellfield VIC 3061
Services and repairs mowers, ride-ons, generators, pumps, trimmers and chainsaws regardless of where they were bought, for brands including Honda, Stihl, Victa, Rover, Masport, Cub Cadet and Briggs & Stratton.
Second workshop in Diamond Creek.
Melbourne Power Tools & Repairs
Shopfront268-272 High St, Preston VIC 3072
Repairs pneumatic, cordless and electric power tools and carries out warranty repairs for power tool brands.
Essendon Mowers
Shopfront561 Keilor Rd, Niddrie VIC 3042
Services lawn mowers, ride-on mowers, brushcutters, blowers, chainsaws and small engines, and sharpens chainsaw chains.
B.W. Machinery
ShopfrontMultiple service centres · South-east
Workshop servicing and repair of lawn mowers, ride-on mowers, chainsaws, brushcutters and other outdoor power equipment.
Service centres in Bentleigh East, Cheltenham, Seaford and Ringwood.
This guide is general information, not professional advice for your specific appliance or situation. Follow your manufacturer's manual where it differs, and read our disclaimer. Spotted an error? Tell us.
More garden & tools guides
Cordless tool battery not charging: what the charger is telling you
18V drill, blower or trimmer battery will not charge? Read the charger lights, check temperature and contacts, and test with a second pack before replacing it.
Whipper snipper won't start or won't feed line: how to fix both
Line trimmer hard to start or the line will not feed? Check the fuel mix, primer bulb, plug and filter, then learn how to rewind the spool so it feeds properly.