Fridge not cooling: what to check before the food spoils
The short answer
A fridge does not make cold so much as move heat. A compressor pumps refrigerant through a cold coil inside the cabinet and a warm coil on the outside, and in most modern fridges a small fan blows the cold air from the freezer section into the fresh food section. Anything that stops heat leaving the outside coil, or stops cold air circulating inside, shows up as a warm fridge.
That is why the pattern matters. If the freezer is still frozen hard but the fridge section is warm, the cooling system itself is probably working and the problem is airflow, usually frost or a failed fan. If both sections are warming up together and the compressor is silent or clicking, the fault is more likely electrical or in the sealed refrigeration system.
The steps below start with the settings and the door, then move to airflow and a manual defrost test. They stop short of removing any panels. Sort out the food first, because that is the part with a deadline.
Likely causes, most common first
Temperature control set too warm or turned off
DIYProblem started after a clean, a big shop or a power cut. The dial has been bumped, or the display shows a demo or holiday mode.
Door not sealing or being left ajar
DIYCondensation or mould on the seal, a door that swings open on its own, or a seal that lets a sheet of paper slide out freely.
Blocked air vents or an overpacked cabinet
DIYSome shelves are cold and others warm. Food is pushed hard against the back wall or stacked in front of the vents.
Dirty condenser coils or not enough clearance
DIYFridge runs almost constantly, the cabinet sides or back are very hot, and cooling is worst on hot days.
Frost-blocked evaporator (defrost system fault)
ProfessionalFreezer still freezes but the fridge section is warm. Frost or snow is visible on the back panel inside the freezer.
Failed fan, start relay, compressor or refrigerant leak
ProfessionalNo fan noise, a click and hum every few minutes from the back, or a compressor that runs hot all day while both sections stay warm.
Before you start
Safety first
- Switch the fridge off at the power point and pull the plug out before cleaning coils, moving the fridge or doing anything behind it.
- Fridges are heavy and top-heavy. Get a second person to help ease one out of its cavity, and watch for the power cord and any water line at the back.
- The compressor and the pipes near it get hot enough to burn. Let the fridge sit for a while after unplugging before you put a hand or a vacuum nozzle near them.
- Do not remove the rear cover over the compressor or the panel inside the freezer. Never pierce, cut or bend any pipework. The refrigerant in many current fridges is flammable, and only a technician with a refrigerant handling licence may work on the sealed system.
- Food that has been above 5°C for more than four hours is not safe to keep, no matter how it looks or smells.
What you will need
- Fridge thermometer, or a glass of water and a kitchen probe thermometer
- Sheet of paper or a banknote (for the door seal test)
- Vacuum cleaner with a brush attachment
- Soft cloth, warm water and a little dish detergent
- Torch
- Esky and ice bricks or bagged ice
- Old towels
Step-by-step checks
Step 1: Measure the temperature and protect the food
Put a fridge thermometer on a middle shelf, or stand a probe thermometer in a glass of water that has been in the fridge for a few hours. The fresh food section should sit at 3 to 4°C and must be at or below 5°C. The freezer should be around -18°C.
If the fridge is above 5°C, move the high-risk food to an esky with ice or to a neighbour's fridge now. That means meat, chicken, seafood, milk, soft cheese, cooked rice and pasta, and leftovers. Australian food safety guidance uses a simple rule for these foods: less than two hours above 5°C in total and they can go back in the cold, two to four hours and they should be eaten straight away, more than four hours and they go in the bin.
Frozen food that is still hard or has ice crystals through it can be refrozen. Food that has thawed but is still fridge-cold should be cooked and eaten within a day or so rather than refrozen.
Tip: Keep the doors shut while you organise somewhere else for the food. A closed fridge holds its temperature far longer than one that is opened every ten minutes to check.
Step 2: Check the power and the temperature setting
If the interior light is off as well, check the power point with another appliance and look at the switchboard for a tripped safety switch or circuit breaker before blaming the fridge.
Then look at the control. A dial inside the fridge is easily knocked while loading, and on most dials a higher number means colder, not warmer. On an electronic display, check that the fridge is not in holiday mode, or in the demo or showroom mode that keeps the lights on with the cooling off. The manual gives the button combination to turn that off.
After changing a setting, give the fridge a full 24 hours to settle before you judge the result.
Step 3: Test the door seals
Close the door on a sheet of paper so that half of it hangs out, then pull. You should feel a clear drag. Repeat every 20 centimetres or so around all four sides of each door. A spot where the paper slides out with no resistance is leaking warm air in.
Wipe the seal and the cabinet face it presses against with warm soapy water. Sticky spills stop a seal closing flat, and they also tear the rubber when the door is pulled open. Check that nothing inside, such as a crisper drawer or a tall bottle, is holding the door off its seal.
The fridge should lean back very slightly so the doors fall closed on their own. If they drift open, wind the front feet down a turn or two.
Step 4: Clear the vents and thin out the load
In a frost-free fridge the cold air enters the fresh food section through vents, usually at the top or along the back wall. A bag of salad or a carton shoved against them can leave the rest of the fridge several degrees too warm.
Pull food away from the back and side walls, leave gaps between items and do the same in the freezer, where the vents and the fan sit behind the back panel. A fridge that is packed solid cannot circulate air, even if every part is working.
Step 5: Check the coils and the space around the fridge
Switch off and unplug, then ease the fridge forward. If there is a black grid of tubing on the back, vacuum the dust off it gently with a brush attachment. Some models have the coil underneath behind a clip-off kick plate at the front, which can be vacuumed the same way.
Many newer fridges have the condenser built into the cabinet walls, so there is nothing to clean and warm sides are normal. What these need is air space. Check the manual for the clearances and make sure the fridge is not boxed in tight by cabinetry, or by bags and trays stored on top and down the sides.
A fridge in a garage or next to an oven works much harder in a Melbourne heatwave. If it only struggles on hot days, heat and ventilation are the likely cause.
Step 6: Listen for the fans and the compressor
Plug the fridge back in and listen. The compressor at the bottom rear should make a steady low hum. On frost-free models there is also a fan in the freezer. It often stops when the door is opened, so hold the door switch in with a finger and listen for it.
A freezer fan that is silent, or that chirps, squeals or rattles as if hitting ice, explains a warm fridge section with a cold freezer. A click followed by a few seconds of humming and another click, repeating every few minutes, means the compressor is trying to start and failing. Both are jobs for a technician, but knowing which one you have makes the booking call more useful.
Step 7: Do a full manual defrost as a test
If the freezer is cold, the fridge is warm and the freezer back panel has frost on it, the cooling coil behind that panel is probably encased in ice. Empty both sections, switch off and unplug, prop the doors open and leave the fridge for 24 to 48 hours with towels on the floor to catch the melt.
Dry the inside, switch back on and let it run empty for several hours before reloading. If the fridge then cools properly, the diagnosis is confirmed. The catch is that the ice formed because the automatic defrost heater, sensor or control is not doing its job, so the problem will usually return within a few weeks. Use that time to get a technician booked.
Careful: Do not speed things up with a hair dryer, heat gun or knife, and do not remove the freezer panel to get at the ice. The coil and its pipes sit directly behind it and are easily punctured.
When to stop and call a repairer
- The compressor clicks on and off every few minutes, or is silent while the light and display work normally.
- The compressor runs constantly and is hot, but neither the fridge nor the freezer gets cold.
- The fridge cooled properly after a manual defrost and then warmed up again within days or weeks.
- The freezer fan is silent or noisy, or you can hear it striking ice.
- The fridge trips the safety switch, or there is a burning smell or an oily residue on the floor at the back.
- You suspect a refrigerant leak. Regassing and any repair to the sealed system can only be done by a technician holding a refrigerant handling licence from the Australian Refrigeration Council.
Anyone who handles refrigerant in a fridge or freezer must hold a refrigerant handling licence issued by the Australian Refrigeration Council. Ask to see it. You can check a licence on the council's Look for the Tick website.
What it costs
- Doing it yourself
- $0 for cleaning, resetting and a manual defrost. A fridge thermometer costs only a few dollars and is worth keeping in there permanently.
- Professional repair
- $220–$480 for a thermostat replacement, $250–$600 for a regas, and $400–$900 or more for a compressor or sealed-system repair. A call-out or diagnostic fee of $80–$200 is common.
Indicative ranges from Australian cost guides, not Melbourne quotes. Ask for a quote after diagnosis and whether the call-out fee is credited against the repair. See our Melbourne repair cost guide for more.
Repair or replace?
Fans, thermostats, sensors, defrost heaters and start relays are ordinary repairs and are usually worth doing on a fridge that is otherwise sound. A fridge that only needed its seals cleaned or its vents cleared needs nothing spent on it at all.
Sealed-system faults are different. A fridge does not use up refrigerant, so one that needs a regas has a leak, and regassing without finding and fixing the leak only buys time. Once a quote involves a compressor or leak repair on a fridge that is past about ten years old, compare it carefully with the price of a new one, and factor in the lower running costs of a newer model.
If the fridge is only a few years old, talk to the retailer before paying for a repair. Under the Australian Consumer Law an appliance must last a reasonable time, which can be longer than the manufacturer's warranty, and the remedy comes from the seller. An old fridge is e-waste in Victoria and cannot go to landfill. Retailers often take the old one on delivery, and council transfer stations accept them and have the refrigerant recovered by the recycler.
Not sure which way to go? Try the repair or replace calculator, and read your consumer rights before paying for a repair on something that failed early.
Common questions
Why is my freezer cold but the fridge warm?
In most frost-free fridges all the cold is made in the freezer and blown into the fridge section by a fan. If the vents are blocked, the fan has failed or the cooling coil is iced over, the freezer stays cold while the fridge warms up. Check the vents first, then try the manual defrost test.
How long will food last in a fridge that has stopped working?
With the door kept shut, a fridge will usually stay cold enough for around four hours. After that, measure rather than guess. High-risk food that has spent more than four hours above 5°C should be thrown out. A full freezer that stays closed can keep food frozen for a day or more.
What number should my fridge dial be on?
The numbers are not degrees. On most fridges a higher number is colder, and a middle setting is the usual starting point. Set it by thermometer: aim for 3 to 4°C in the fridge and about -18°C in the freezer, and wait 24 hours between adjustments.
Can I regas a fridge myself?
No. Handling refrigerant in Australia requires a refrigerant handling licence issued by the Australian Refrigeration Council, and the system has to be leak-tested and repaired first for a regas to last. This is strictly a job for a licensed technician.
The sides of my fridge are hot. Is that a fault?
Usually not. Many modern fridges shed their heat through pipes built into the cabinet walls, so the sides feel warm, and quite hot on a summer day or after a big load of groceries. It is only a concern if the fridge is also failing to cool or the heat is new and extreme.
Melbourne repairers for fridges & freezers
Independent businesses that list this kind of work. Listings are free and are not endorsements. Always confirm prices, licences and availability directly.
Woolley Appliance Services
Shopfront & mobile10 Freight Rd, Ravenhall VIC 3023
Repairs Samsung and LG refrigerators, washing machines, dryers, dishwashers, TVs, monitors, soundbars, microwaves and vacuum cleaners, in-home or in its workshops.
Authorised Samsung and LG service centre. Second workshop in Clayton.
WAM Electrical
Shopfront & mobile50A Hartnett Dr, Seaford VIC 3198
Repairs washing machines, dryers, fridges, dishwashers, ovens and cooktops across Melbourne and sells appliance spare parts.
DP Electric
Mobile service12 Brodribb Rd, Clyde North VIC 3978
In-home repairs of dishwashers, washing machines, dryers, fridges, ovens, cooktops and rangehoods.
Services south-east Melbourne, the eastern suburbs, Bayside and the Mornington Peninsula.
RapidFix Solutions
Mobile service113 East St, Hadfield VIC 3046
On-site repairs of ducted gas and reverse-cycle heating, split system, ducted and evaporative cooling, domestic fridges and freezers, washing machines, dryers, dishwashers, ovens and cooktops.
Services Glenroy, Coburg, Brunswick, Pascoe Vale, Essendon and other suburbs.
This guide is general information, not professional advice for your specific appliance or situation. Follow your manufacturer's manual where it differs, and read our disclaimer. Spotted an error? Tell us.
More fridges guides
Fridge leaking water inside or onto the floor: causes and fixes
Water under the crisper or a puddle on the kitchen floor? Clear the defrost drain, check the drip tray, levelling and water line, and know when to call.
Freezer frosting up or full of ice: causes and how to defrost safely
Freezer walls thick with frost or drawers jammed with ice? Find out why it is happening, how to defrost safely and when a frost-free fault needs a technician.