Skip to content
MelbourneFixFix it, or find someone in Melbourne who can

Freezer frosting up or full of ice: causes and how to defrost safely

Easy20 minutes of checks, plus 3–6 hours for a full defrostReviewed By the MelbourneFix team

The short answer

Frost comes from moist room air getting into the freezer, usually through a door that is not sealing or closing fully. Fix the air leak, defrost properly, and call a technician if a frost-free model ices up again on the back panel.

Frost is frozen humidity. Every time room air gets into a freezer, the moisture in it freezes onto the coldest surface it can find. A light dusting is unavoidable. Thick fur on the walls, snow on the food or drawers welded in place with ice mean far more moist air is getting in than should be, or that the freezer's automatic defrost has stopped working.

It helps to know which type of freezer you have. Manual-defrost freezers, which include most chest freezers and many basic uprights, have cooling coils in the walls or shelves and build up ice slowly as a matter of course. They need defrosting by hand when the ice gets thick. Frost-free freezers hide the cooling coil behind a back panel and melt the frost off it automatically with a small heater several times a day. A frost-free freezer should never need defrosting, so if it is icing up, something is wrong.

Where the frost forms is the best clue. Work through the checks below before you defrost, so that the ice does not simply come back.

Likely causes, most common first

  • Door not closing fully

    DIY

    Frost is heaviest near the door opening. A drawer, a bag or an overfull shelf is stopping the door meeting the cabinet.

  • Dirty, flattened or split door seal

    DIY or professional

    Frost or ice builds along one edge or corner of the opening. A sheet of paper slides out of the closed door with no drag at that spot.

  • Warm or uncovered food and frequent door opening

    DIY

    Fine snow over the food and packaging rather than on the walls, worse after a big cook-up or in humid weather.

  • Manual-defrost freezer due for a defrost

    DIY

    Even layer of hard ice on the walls or shelf coils that has built up over months. Chest freezer or basic upright with no fan.

  • Frost-free defrost system fault

    Professional

    Frost or snow spreading across the back panel inside a frost-free freezer. The fridge section may be getting warm at the same time.

  • Frozen defrost drain

    DIY or professional

    Sheet of clear, solid ice on the floor of a frost-free freezer, sometimes with water dripping into the fridge section or onto the kitchen floor.

Before you start

Safety first

  • Switch off at the power point and unplug before defrosting or cleaning. Meltwater and a live appliance are a bad combination.
  • Never chip at ice with a knife, screwdriver or any metal tool. The refrigerant pipes run just under the lining, and one slip can puncture them and write off the freezer.
  • Do not use a hair dryer, heat gun or fan heater. They can warp or melt the plastic lining, and using mains-powered heat around pooling water is an electric shock risk.
  • Keep towels down and mop as you go. Water on a tiled or polished floor is easy to slip on.
  • Keep the frozen food cold while you work. Food that has fully thawed and warmed above 5°C for more than four hours should be thrown out.

What you will need

  • Esky, ice bricks or bagged ice, and newspaper or a doona to insulate the food
  • Old towels
  • Plastic scraper or plastic spatula
  • Saucepans or bowls of hot water and a wooden board or folded tea towel to stand them on
  • Shallow tray or baking dish
  • Sponge and a soft cloth
  • Sheet of paper (for the seal test)
  • Freezer thermometer

Step-by-step checks

  1. Step 1: Read the frost pattern

    Before you disturb anything, look at where the ice is. Frost concentrated around the door opening, on the front of the top shelf or along one edge is room air leaking in past the door. Light snow over all the food points to moisture from the food itself or a door that is open a lot.

    On a frost-free model, frost spread over the back panel or blocking the vents in it means the hidden coil is not being defrosted. A flat slab of clear ice on the floor is meltwater that could not get down the drain and froze instead.

  2. Step 2: Make sure the door can close

    Push every drawer and basket fully home and check nothing is poking out past the shelf fronts. In an upright freezer a single frozen bag hanging over the edge is enough to hold the door open a few millimetres.

    Check that the freezer leans back slightly so the door falls shut, and that door bins or a build-up of ice on the cabinet face are not fouling the seal. On chest freezers, make sure nothing stacked above the rim is holding the lid up.

    Tip: If the door is hard to open again straight after closing it, that is normal. Warm air that got in cools and contracts, creating suction. Wait half a minute rather than yanking on the seal.

  3. Step 3: Clean and test the seal

    Wipe the seal and the surface it presses against with warm water and a little dish detergent, including down in the folds. Dry it properly. Look for splits, sections that have come out of their groove and corners that stay flattened.

    Close the door on a sheet of paper and pull it out, repeating all the way around. The paper should drag everywhere. A seal that fails the test in one spot after cleaning, or that is torn, needs replacing. Some seals push into a groove and can be ordered by model number and fitted at home. Others are screwed or bonded behind the door liner and are better left to a repairer.

  4. Step 4: Change how food goes in

    Let hot food cool until it stops steaming, chill it in the fridge, then freeze it. Hot food dumps steam into the freezer, and that steam becomes frost. Keep everything wrapped or in lidded containers, and squeeze the air out of freezer bags.

    Decide what you want before opening the door, and close it promptly. A reasonably full freezer holds its temperature better than an empty one, but do not pack food against the vents on the back panel of a frost-free model.

  5. Step 5: Defrost the freezer properly

    Pack the frozen food tightly into an esky with ice bricks, or stack it in a box and wrap it in newspaper and a doona. Switch off and unplug the freezer, open the door and lay towels along the floor at the front. On a chest freezer, pull the drain bung at the bottom and put a shallow tray under the outlet.

    Stand saucepans or bowls of hot water inside on a wooden board or folded tea towel and close the door. The steam loosens the ice in 15 to 20 minutes. Replace the water as it cools. As the ice lets go, lift it off in sheets by hand or ease it away with a plastic scraper and put it in the sink.

    When all the ice is gone, wipe the inside with a cloth and dry it thoroughly. Any water left behind becomes the first layer of new ice.

    Careful: Do not force ice that is still stuck. If it will not lift away with light pressure from a plastic scraper, it needs more time. Levering at it is how linings get cracked and pipes get punctured.

  6. Step 6: Restart and watch how fast the frost returns

    Plug the freezer in and let it run empty until it is back to about -18°C, which usually takes a few hours, then reload the food. Note the date.

    A manual-defrost freezer with a good seal should go many months before it needs doing again. As a guide, defrost it when the ice is about half a centimetre thick, because ice acts as insulation and makes the freezer run longer. If a frost-free freezer has frost across its back panel again within a few weeks, the defrost heater, sensor, timer or control board has failed and it is time to call a technician.

When to stop and call a repairer

  • A frost-free freezer ices up on the back panel again within weeks of a full defrost.
  • The freezer is frosting up and the fridge section above or beside it is getting warm.
  • You can hear the freezer fan hitting ice, or the fan has stopped altogether.
  • A slab of ice keeps forming on the freezer floor after a full defrost. The drain behind the panel needs clearing or its heater has failed.
  • The door seal is torn or will not seal and is the screwed-in or bonded type.
  • Ice was chipped at and the freezer has since stopped cooling, or you heard a hiss. Unplug it, ventilate the room and call a technician licensed to handle refrigerant.

Anyone who handles refrigerant in a fridge or freezer must hold a refrigerant handling licence issued by the Australian Refrigeration Council. Ask to see it. You can check a licence on the council's Look for the Tick website.

What it costs

Doing it yourself
$0 for a manual defrost and seal clean. A push-in replacement door seal is priced by model, so get the part number from the rating plate and ask a spare parts supplier.
Professional repair
A defrost system repair needs a quote after diagnosis. Expect a call-out fee of $80–$200, and as a guide to scale, a fridge thermostat replacement is typically $220–$480. Sealed-system repairs after a puncture run to $400–$900 or more.

Indicative figures from Australian cost guides, not Melbourne quotes. Ask whether the call-out fee comes off the repair price if you go ahead. See our Melbourne repair cost guide for more.

Repair or replace?

Seals, defrost heaters, sensors and timers are routine repairs. On a frost-free fridge-freezer in good condition they are usually worth doing, because the cooling system itself is still healthy.

A punctured lining is another matter. Repairing a hole in the refrigerant circuit and regassing is licensed work, is not always possible where the pipe is embedded in the cabinet foam, and on a small or older freezer it often costs more than the freezer is worth. That is the whole reason for the rule about knives.

If you do replace it, an old freezer is e-waste in Victoria and cannot go to landfill. Council transfer stations and many retailers accept them, and the recycler recovers the refrigerant before the cabinet is scrapped. If the freezer is fairly new and its defrost system has failed, speak to the retailer first, as the Australian Consumer Law requires appliances to last a reasonable time.

Not sure which way to go? Try the repair or replace calculator, and read your consumer rights before paying for a repair on something that failed early.

Common questions

How often should I defrost a freezer?

A manual-defrost freezer usually needs it once or twice a year, or whenever the ice reaches about half a centimetre thick. A frost-free freezer should not need defrosting at all. If it does, the door is leaking air or the automatic defrost has a fault.

Can I use a hair dryer to defrost my freezer faster?

We advise against it. The hot air can distort the plastic lining, and you would be holding a mains appliance over a cabinet full of meltwater. Bowls of hot water with the door closed are nearly as quick and carry none of that risk.

Is frost on my frozen food a safety problem?

No. Frost and freezer burn affect texture and flavour, not safety, as long as the food has stayed frozen. Dry, pale patches can be trimmed off. Heavy frost inside packets does suggest the freezer temperature has been going up and down, so check it with a thermometer.

Why does my frost-free freezer have ice on the back wall?

The cooling coil sits behind that panel. When the automatic defrost stops working, frost builds on the coil until it pushes through the vents and across the panel. A full manual defrost gets it going again for a while, but the faulty heater, sensor or control needs a technician.

How long will food stay frozen while I defrost?

Packed tightly in a good esky with ice bricks, or boxed and wrapped in several layers of newspaper and a doona, food will stay frozen for the few hours a defrost takes. Do the job on a cool day if you can, and keep the food out of the sun.

Melbourne repairers for fridges & freezers

Independent businesses that list this kind of work. Listings are free and are not endorsements. Always confirm prices, licences and availability directly.

Woolley Appliance Services

Shopfront & mobile

10 Freight Rd, Ravenhall VIC 3023

Repairs Samsung and LG refrigerators, washing machines, dryers, dishwashers, TVs, monitors, soundbars, microwaves and vacuum cleaners, in-home or in its workshops.

Authorised Samsung and LG service centre. Second workshop in Clayton.

DP Electric

Mobile service

12 Brodribb Rd, Clyde North VIC 3978

In-home repairs of dishwashers, washing machines, dryers, fridges, ovens, cooktops and rangehoods.

Services south-east Melbourne, the eastern suburbs, Bayside and the Mornington Peninsula.

RapidFix Solutions

Mobile service

113 East St, Hadfield VIC 3046

On-site repairs of ducted gas and reverse-cycle heating, split system, ducted and evaporative cooling, domestic fridges and freezers, washing machines, dryers, dishwashers, ovens and cooktops.

Services Glenroy, Coburg, Brunswick, Pascoe Vale, Essendon and other suburbs.

See all fridges repairers

This guide is general information, not professional advice for your specific appliance or situation. Follow your manufacturer's manual where it differs, and read our disclaimer. Spotted an error? Tell us.

More fridges guides

Fridges

Fridge not cooling: what to check before the food spoils

Fridge warm but the light still works? Check the thermostat, door seals, vents and coils, learn the 5°C food rule and know when to call a technician.

Easy30–60 minutes, plus 24–48 hours if a manual defrost is needed