Fridge leaking water inside or onto the floor: causes and fixes
The short answer
Every fridge makes water. Moisture from the air and from food freezes onto the cold surfaces, and the fridge melts it off at regular intervals. That meltwater is meant to run down a channel, through a small drain hole and a tube, and into a shallow tray near the warm compressor, where it evaporates without you ever seeing it.
A leak is nearly always that path being interrupted. Block the drain hole with a crumb or a slip of lettuce and the water overflows into the bottom of the fridge instead. Tilt the fridge the wrong way and it runs to the front. Fridges with a water dispenser or ice maker add a second source: a pressurised water line that can drip at a joint or at the filter.
Where the water turns up tells you most of what you need to know, so start by working out exactly where it is coming from.
Likely causes, most common first
Blocked defrost drain
DIYWater pools under the crisper drawers or on the bottom shelf and comes back a day or two after you mop it out.
Food or containers touching the back wall
DIYWet patches on shelves directly below something pressed against the back of the fridge. Droplets or a thin layer of ice on the back wall are normal.
Door not sealing, causing heavy condensation
DIYWater beads on the ceiling, shelves and around the door seal, worst in humid weather. The fridge runs more than usual.
Fridge not level
DIYWater runs to the front and drips out under the door. Doors do not swing shut by themselves.
Drip tray cracked, out of place or overflowing
DIY or professionalPuddle on the floor at the back or underneath, with the inside of the fridge dry.
Leaking water line, filter or inlet valve (plumbed models)
ProfessionalSteady drip or puddle that continues whether or not the fridge is defrosting. Often starts after a filter change or after the fridge was moved.
Before you start
Safety first
- Switch the fridge off at the power point and unplug it before moving it or reaching behind or underneath it. Mop up first so you are not standing in water while handling the plug.
- Water on a hard kitchen floor is a slip hazard, and water left under a fridge will swell chipboard cabinetry and lift floating floors. Dry it up promptly.
- On a plumbed fridge, turn off the isolating tap that feeds the water line before touching the line or the filter.
- The compressor and nearby pipes at the rear are hot when the fridge has been running. Do not remove the rear cover or bend any pipework.
- Get help to move the fridge. Pull it straight out so you do not kink the water line or run over the power cord.
What you will need
- Old towels and a sponge
- Torch
- Cotton buds or a flexible pipe cleaner
- Turkey baster, sauce bottle or large syringe
- Jug of warm water
- Spirit level, or a level app on your phone
- Paper towel (to find slow drips)
Step-by-step checks
Step 1: Work out where the water is coming from
Dry everything, inside and out. Lay a sheet of paper towel under the crisper drawers, another on the floor at the front of the fridge and, if you can reach, one at the back. Check them over the next day.
Water inside the cabinet points to the defrost drain or condensation. A dry interior with water on the floor points to the drip tray or, on a plumbed fridge, the water supply. Clear water is meltwater or mains water. If the liquid is coloured or sticky, look for a leaking bottle or container before anything else.
Step 2: Move food off the back wall
On fridges where the back wall of the fresh food section is the cold surface, you will see it frost over and then run with droplets as it defrosts. That is normal. The droplets run down the wall into a small channel at the bottom.
Anything touching the wall gives the water a bridge. It runs along the container or bag and drips onto the shelf below instead of into the channel. Keep a gap of a few centimetres between food and the back wall, and the mysterious wet shelf often stops on its own.
Step 3: Clear the defrost drain hole
Take out the crisper drawers and the lowest shelf and look at the bottom of the back wall. On most fridges of this type there is a narrow channel with a drain hole in the middle, sometimes with a small plastic cleaning tool sitting in it. Wipe the channel clean of crumbs and slime.
Work the cleaning tool, a cotton bud or a flexible pipe cleaner gently up and down in the hole to break up the blockage. Then use a turkey baster or sauce bottle to squirt warm water into the hole. It should disappear straight down. If it wells up and sits there, keep working at it and flush again.
The water you flush through ends up in the drip tray at the back and will evaporate, so use a cup or so at a time rather than litres.
Tip: Flushing the drain with warm water every few months, when you clean the fridge, stops the blockage building up again.
Careful: Use warm water, not boiling, and nothing sharp or rigid such as a skewer or coat-hanger wire. The drain tube is thin plastic and you do not want to split it or push it off its fitting.
Step 4: If you cannot see a drain, defrost the whole fridge
On many frost-free fridges the drain is hidden behind a panel in the freezer section, where it can freeze solid. The sign is a sheet of ice on the freezer floor, or water under the crispers on a model with the freezer on top, with no visible drain hole in the fridge section.
Do not remove the panel. Instead empty the fridge, switch off and unplug, prop the doors open and leave it for 24 hours with towels down. This melts the ice plug in the drain. If the leak returns within a few weeks, the drain needs clearing properly or its heater has failed, and that is a technician's job.
Step 5: Check the levelling and the door seal
Put a level on top of the fridge. It should be level side to side and lean back very slightly, enough that an open door swings shut by itself. A fridge that leans forward sends meltwater to the front lip instead of the drain. Wind the front feet down to correct it.
Then check the seals. A door that does not seal lets humid air pour in, and the fridge can make more condensation than the drain can handle. Wipe the seal with warm soapy water and close the door on a sheet of paper at several points. The paper should drag as you pull it out.
Step 6: Inspect the drip tray
Switch off, unplug and ease the fridge forward. With a torch, look low at the back for a shallow plastic or metal tray, usually sitting above or beside the compressor. Some water in it is normal.
Check that the tray is sitting flat in its supports, is not cracked and that the drain tube ends over it rather than beside it. On some models the tray slides out for cleaning, and on others it is fixed and can only be sponged out. If it is brim-full, the usual reason is a door that has been left ajar or a failing seal making far more meltwater than normal.
Step 7: On a plumbed fridge, check the water line and filter
Follow the thin water line from the wall or the cupboard next door to the back of the fridge. Run a dry paper towel along it and around each joint. A kinked, crushed or chafed line is common after a fridge has been pushed back into place.
If the leak started after a filter change, turn off the isolating tap, remove the filter and refit it, making sure it is the correct type and is turned or pushed fully home. Check the housing for a missing or pinched rubber ring.
If a joint or the line itself is dripping, leave the isolating tap off and call a plumber or appliance technician. The fridge will keep cooling normally without its water supply.
When to stop and call a repairer
- Water returns inside the fridge within weeks of a full defrost, and there is no drain hole you can reach.
- A water line, joint or the inlet valve at the back of a plumbed fridge is dripping. Turn the isolating tap off while you wait.
- The drip tray is cracked, or the drain tube has come away and you cannot reach it without removing a cover.
- The fridge is leaking and also not cooling properly, or the compressor is running constantly.
- Water has reached the power point, or the fridge trips the safety switch. Leave it switched off at the switchboard until it has been checked.
Anyone who handles refrigerant in a fridge or freezer must hold a refrigerant handling licence issued by the Australian Refrigeration Council. Ask to see it. You can check a licence on the council's Look for the Tick website.
What it costs
- Doing it yourself
- $0 in most cases. Clearing a drain, levelling the fridge and cleaning the seals need nothing you do not already have in the kitchen.
- Professional repair
- Expect a call-out or diagnostic fee of $80–$200, with parts and labour on top. As a guide to scale, replacing a control part such as a fridge thermostat is typically $220–$480.
Indicative figures from Australian cost guides, not Melbourne quotes. Ask whether the call-out fee is credited against the repair, and get a quote before work starts. See our Melbourne repair cost guide for more.
Repair or replace?
A leak on its own is almost never a reason to replace a fridge. The usual causes are a blocked drain, a seal or a fitting, and none of them say anything about the health of the cooling system.
The exception is a leak that comes with poor cooling on an older fridge, where the water is a symptom of a defrost or sealed-system fault. In that case have the fault diagnosed and weigh the quote against the age of the fridge.
If a fairly new fridge leaks because of a faulty part, such as an inlet valve or a drain heater, raise it with the retailer. Under the Australian Consumer Law an appliance must last a reasonable time, which can be longer than the manufacturer's warranty.
Not sure which way to go? Try the repair or replace calculator, and read your consumer rights before paying for a repair on something that failed early.
Common questions
Why is there water under my crisper drawers?
The defrost drain is blocked. Meltwater that should run out through the drain hole at the back of the fridge is overflowing and collecting at the lowest point, which is under the crispers. Clearing and flushing the drain hole fixes it in most cases.
Is water running down the back wall of my fridge normal?
Yes, on fridges where the back wall is the cooling surface. It frosts lightly while the compressor runs and the frost melts and runs down to the drain when it stops. It only becomes a problem if the drain is blocked or food is touching the wall.
Can a leaking fridge damage my floor?
It can. A slow leak under a fridge often goes unnoticed for weeks, which is long enough to swell chipboard kickboards, stain timber and lift laminate or floating floors. If you find water, pull the fridge out and dry underneath, not just the part you can see.
Is it safe to keep using the fridge while it is leaking?
If the water is staying inside the cabinet and the fridge is cooling properly, yes. Mop it out daily until you clear the drain. If water is reaching the floor near the power point or coming from a plumbed water line, switch off and deal with it straight away.
Do I need a plumber or an appliance technician for a leaking fridge?
For a leak from the house side of the water line, such as the isolating tap or the pipe in the wall or cupboard, call a licensed plumber. For anything on the fridge itself, including the inlet valve, internal tubing and the defrost drain, call an appliance technician.
Melbourne repairers for fridges & freezers
Independent businesses that list this kind of work. Listings are free and are not endorsements. Always confirm prices, licences and availability directly.
Woolley Appliance Services
Shopfront & mobile10 Freight Rd, Ravenhall VIC 3023
Repairs Samsung and LG refrigerators, washing machines, dryers, dishwashers, TVs, monitors, soundbars, microwaves and vacuum cleaners, in-home or in its workshops.
Authorised Samsung and LG service centre. Second workshop in Clayton.
WAM Electrical
Shopfront & mobile50A Hartnett Dr, Seaford VIC 3198
Repairs washing machines, dryers, fridges, dishwashers, ovens and cooktops across Melbourne and sells appliance spare parts.
DP Electric
Mobile service12 Brodribb Rd, Clyde North VIC 3978
In-home repairs of dishwashers, washing machines, dryers, fridges, ovens, cooktops and rangehoods.
Services south-east Melbourne, the eastern suburbs, Bayside and the Mornington Peninsula.
RapidFix Solutions
Mobile service113 East St, Hadfield VIC 3046
On-site repairs of ducted gas and reverse-cycle heating, split system, ducted and evaporative cooling, domestic fridges and freezers, washing machines, dryers, dishwashers, ovens and cooktops.
Services Glenroy, Coburg, Brunswick, Pascoe Vale, Essendon and other suburbs.
This guide is general information, not professional advice for your specific appliance or situation. Follow your manufacturer's manual where it differs, and read our disclaimer. Spotted an error? Tell us.
More fridges guides
Fridge not cooling: what to check before the food spoils
Fridge warm but the light still works? Check the thermostat, door seals, vents and coils, learn the 5°C food rule and know when to call a technician.
Freezer frosting up or full of ice: causes and how to defrost safely
Freezer walls thick with frost or drawers jammed with ice? Find out why it is happening, how to defrost safely and when a frost-free fault needs a technician.