Skip to content
MelbourneFixFix it, or find someone in Melbourne who can

Phone or tablet not charging or charging slowly: what to check first

Easy15–30 minutesReviewed By the MelbourneFix team

The short answer

Most charging faults are a worn cable, an underpowered charger or pocket lint packed into the charging port, and all three can be sorted at home. A battery or charging port that has genuinely failed is a job for a repairer.

A phone that will not charge feels urgent, but the fault is usually outside the phone. Charging depends on a chain of four things: the power point, the charger, the cable and the port on the device. The cable and the port take the most physical abuse, so that is where most problems turn up.

Slow charging is a slightly different problem. Modern phones and tablets negotiate with the charger to decide how much power to draw. If the charger is an old low-wattage one, or the cable cannot carry fast charging, the device falls back to a trickle. An iPad plugged into a small phone charger can take most of a day to fill.

The steps below work for iPhones, iPads and Android phones and tablets. They start with swaps that cost nothing and finish with a battery health check, which tells you whether a repairer needs to be involved.

Likely causes, most common first

  • Worn or damaged cable

    DIY

    Charging starts and stops when the cable is moved, or only works at a certain angle. The cable may be kinked or frayed near either plug.

  • Lint or dirt packed into the charging port

    DIY

    The plug no longer clicks fully home, feels spongy or falls out easily. Common in phones carried in jeans pockets or bags.

  • Underpowered or faulty charger

    DIY

    Charging works but is very slow, or a tablet shows that it is not charging when plugged into a computer or an old small charger.

  • Software, heat or moisture protection pausing the charge

    DIY

    The device stops at 80 per cent, shows a temperature or liquid warning, or charges normally after a restart.

  • Worn-out battery

    Professional

    Battery drains quickly, the percentage jumps around, or the device shuts down with charge apparently left. Usually a device more than two or three years old.

  • Damaged charging port or internal charging fault

    Professional

    Port is clean and several known-good cables all fail, the plug wobbles, or the fault began after a drop or water exposure.

Before you start

Safety first

  • If the phone or tablet is swollen, the screen is lifting away from the frame, or the device is hot, hissing or smells sweet or chemical, do not charge it or use it. Put it somewhere non-flammable, such as on concrete outside and away from anything that burns, and take it to a repairer.
  • Never open a charger or power adaptor. They are connected to mains voltage and have no user-serviceable parts. A charger that is cracked, buzzing, discoloured or too hot to hold goes in the e-waste, not back in the power point.
  • Use chargers that carry the Regulatory Compliance Mark (a tick inside a triangle), which shows they are approved for sale in Australia. Very cheap unbranded chargers bought online are a known fire and shock risk.
  • Switch the device off before cleaning the charging port, and never put anything metal into it.
  • Charge on a hard surface. A phone charging under a pillow or on a doona cannot shed heat.

What you will need

  • A second cable and charger that you know work
  • Wooden or plastic toothpick
  • Torch
  • Soft dry toothbrush or small anti-static brush

Step-by-step checks

  1. Step 1: Rule out the power point and give a flat battery time

    Plug the charger into a different power point, and check the switch is on. Power boards with their own switches or overload buttons are a common trap. If you are charging from a computer, a car or a USB socket built into a wall plate or lamp, move to a proper wall charger for the test, because those sources often supply very little power.

    A battery that has gone completely flat may show nothing at all for the first ten to fifteen minutes. Leave the device connected to a wall charger for half an hour before deciding it is dead.

  2. Step 2: Swap the cable, then the charger

    Change one thing at a time so you know which part was at fault. Start with the cable, since cables fail far more often than chargers. Borrow one from a household member whose device charges normally with it.

    If a new cable makes no difference, swap the charger. For slow charging, read the fine print on the charger body. An old 5 watt phone charger will charge a current phone slowly and a tablet painfully slowly. Most recent phones want a USB-C charger of 20 watts or more, and tablets do better with 30 watts or more.

    Tip: Not every USB-C cable carries fast charging. If the device charges quickly on the cable that came with it but slowly on a spare, the cable is the limit.

  3. Step 3: Inspect and clean the charging port

    Switch the device off and shine a torch into the port. A clean port shows bare metal at the bottom. A grey or fuzzy layer is compacted lint, and it stops the plug from seating fully.

    Use a wooden or plastic toothpick to gently lift the lint out, working along the edges of the port rather than scraping the contacts. On USB-C ports there is a thin central tongue that carries the contacts, so work around it and do not lever against it. Finish with a soft dry brush. It is common to remove a surprising plug of fluff.

    Manufacturers generally advise against putting objects into the port, so if you are not comfortable doing this, a phone repairer can clean it in a few minutes.

    Careful: Do not use pins, paper clips or anything metal, and do not use liquids or sprays. If the port contacts look green, black or bent, stop and have a repairer look at it.

  4. Step 4: Restart and check the charging settings

    Restart the device. If the screen is frozen or black, do a forced restart using the button combination for your model, which the manufacturer's support site lists. A phone that has crashed with a black screen can look exactly like a phone that will not charge.

    Then check the battery settings. iPhones, iPads, Samsung and Google devices all have options that deliberately hold the charge at around 80 per cent, or delay the last part of the charge overnight, to slow battery ageing. A device that stops at 80 per cent is usually doing what it was told.

    Install any pending system update as well. Charging behaviour is controlled by software and is occasionally fixed by an update.

  5. Step 5: Check for heat and moisture warnings

    Phones pause charging when they are too hot. A phone on a car dashboard, in direct sun or running navigation in a windscreen cradle on a Melbourne summer day will often stop charging until it cools. Take it out of its case, move it into the shade and try again in twenty minutes.

    If you see a liquid or moisture warning, unplug the cable and leave the device in a dry, airy spot with the port facing down. It can take several hours for the port to dry. Do not push the warning aside and keep charging, and do not use a hair dryer on it.

  6. Step 6: Try wireless charging as a test

    If your phone supports wireless charging, place it on a wireless pad. If it charges normally there but not by cable, the battery and charging circuit are healthy and the fault is in the port or the cables.

    If wireless charging is the thing that has stopped working, remove the case and anything stuck to the back of the phone. Thick cases, metal plates for car mounts, pop-out grips and bank cards all block it. Centre the phone on the pad, and make sure the pad itself is plugged into a charger with enough output.

  7. Step 7: Check the battery's health

    On an iPhone or iPad, look under Battery in Settings for the battery health reading. Recent Android phones show similar information in the battery settings or in the manufacturer's support app, such as Samsung Members.

    A maximum capacity of around 80 per cent or lower, or a message saying the battery needs service, means the battery is worn. It will still charge, but it will run down quickly and may shut the device off under load. That is a replacement job rather than a charging fault.

When to stop and call a repairer

  • The device is swollen, the back or screen is lifting, or it gets hot while charging. Stop using it and do not charge it again.
  • Several known-good cables and chargers all fail and the port is clean, or the plug is loose and wobbles in the port.
  • The charging fault started after the device was dropped or got wet.
  • Battery health shows a service message, or the device shuts down with 20 or 30 per cent showing.
  • You see a burnt or melted mark on the plug or port, or smell burning.

A repairer who accepts a device that stores your data must give you a written repair notice warning that data may be lost. Take that seriously. Back up to iCloud, Google or a computer before any repair, and remove your SIM and any memory card.

What it costs

Doing it yourself
$0 for cleaning the port and changing settings. A replacement cable or charger varies by brand and wattage, so buy one with the Regulatory Compliance Mark from a mainstream retailer.
Professional repair
Roughly $109–$149 for a phone battery replacement at an independent repairer. Charging port repairs vary widely by model, so ask for a quote.

Indicative ranges from 2026 Australian cost guides. Manufacturer service centres and tablets are often priced differently, so get a firm quote before agreeing to the work. See our Melbourne repair cost guide for more.

Repair or replace?

A new battery is one of the best-value repairs there is. If the phone is otherwise in good condition and still receives software updates, a battery replacement can give it another two or three years for a fraction of the price of a new handset.

It is a harder call when the device no longer receives security updates, or when it needs a battery and a screen and a charging port at once. Add the quotes together and compare the total with the price of a current mid-range phone.

If the device is fairly new and the battery or charging has failed without any damage on your part, talk to the seller before paying for a repair. Under the Australian Consumer Law a product must last a reasonable time, which can be longer than the manufacturer's warranty, and the remedy comes from the business that sold it to you.

Not sure which way to go? Try the repair or replace calculator, and read your consumer rights before paying for a repair on something that failed early.

Common questions

Why does my phone say it is charging but the percentage does not go up?

The charger is supplying less power than the phone is using. This happens with weak chargers, computer USB ports and worn cables, especially while the screen is on or the phone is hot. Try a wall charger of 20 watts or more with a good cable and leave the screen off.

Is it safe to clean a charging port with a toothpick?

With the phone switched off, a wooden or plastic toothpick used gently is the usual home method and it clears most lint blockages. The risk is bending the contacts by digging or levering. Never use metal, and if the lint will not shift easily, ask a repairer to do it.

Does fast charging or charging overnight damage the battery?

Not in any way worth worrying about on a current phone. The phone controls the charge rate and slows down as it fills. Heat does more harm than charging habits, so keep the phone out of the sun and off soft bedding while it charges. Turning on the 80 per cent limit helps if you plan to keep the phone for many years.

Can I replace my phone's battery myself?

We recommend against it. Modern phone batteries are glued in and easy to puncture during removal, and a punctured lithium-ion battery can catch fire. Australian fire services advise having battery replacements done by qualified people. A repairer will also dispose of the old battery correctly.

What do I do with an old phone battery or charger?

Neither can go in a household bin. Victoria bans e-waste from landfill, and lithium batteries cause fires in rubbish trucks. Take loose batteries to a B-cycle drop-off point, which many supermarkets and hardware stores have, and take old chargers and cables to a council e-waste collection point.

Melbourne repairers for phones & tablets

Independent businesses that list this kind of work. Listings are free and are not endorsements. Always confirm prices, licences and availability directly.

Fixspot Repair Centre

Shopfront

207/125 Swanston St, Melbourne VIC 3000

Repairs iPhones, iPads, Apple Watch, MacBooks, Samsung Galaxy phones and tablets, Microsoft Surface devices and phones from Google Pixel, Oppo, Xiaomi, Motorola and Nokia.

Second store in Point Cook.

City Phones

Shopfront

148 Elizabeth St, Melbourne VIC 3000

Repairs iPhone, Samsung, Google Pixel, Oppo and other phones, iPads, Samsung tablets, Apple Watch and Microsoft Surface devices, including motherboard repair and data recovery.

Also in Greensborough and St Kilda.

Mister Click

Shopfront

167 King St, Melbourne VIC 3000

Repairs iPhone, Samsung Galaxy, Google Pixel and other phones, iPads, MacBooks and laptops, and lists PlayStation and Nintendo Switch console repairs. Mail-in available.

Second location at 480 Collins St.

Phonebot Repairs

Shopfront

Shop A, 289-291 Broadway, Reservoir VIC 3073

Repairs iPhones, Samsung Galaxy phones, iPads and tablets, and Apple and Samsung smartwatches, with walk-in and mail-in options.

See all phones repairers

This guide is general information, not professional advice for your specific appliance or situation. Follow your manufacturer's manual where it differs, and read our disclaimer. Spotted an error? Tell us.

More phones guides